02 · Seawater

Grow-out
sites

Barges with automatic and semi-automatic pneumatic systems, for rent or purchase, controlled from any device.

All solutions

Feeding, control and services for barges, all from a single supplier. We design, install and maintain feeding systems for seawater sites: we take charge of the equipment, of the software that controls it and of its maintenance throughout the cycle. That way your operation has a single technical contact, in Chile.

  • 87% of remote support cases resolved within 24 hours.
  • 100% of critical failures resolved.
  • Maintenance for HUBER equipment and other brands.
Circular sea cages at a grow-out site

How the feeding flow works

Four stages, all controlled from the control software

The feed goes through four stages, and you monitor and control all of them from the software.

StageWhat it does
01 · BlowingA blower generates a constant air flow that carries the feed along the line.
02 · DosingFeed leaves the silo regulated by a helical auger, in the exact amount you program in the software.
03 · DeliveryA rotary airlock introduces the portioned feed into the line towards the cage.
04 · SelectionSelector valves route the feed to each cage, as you define in the software.

System equipment

From the control software to every cage

Blower, dosing screw, selector valves and HUBER spreader: this is how every piece of the system connects.

Diagram of the HUBER feeding system for sea cages: control software, blower, dosing screw, selector valves and spreaders in every cage

Maintenance programme for seawater sites

A visit plan designed so that your feeding never stops: we inspect, adjust and look after your installation throughout the cycle.

We are with you from before stocking until the end of the cycle, with scheduled visits, a report after each one and remote support at no additional cost. We also maintain equipment from other brands. We operate from Region IV to Region XII.

  1. Commissioning

    We leave the system ready before you start: inspection of selector valves, blowers, dosers or screws, panels and software. Includes configuration, operating tests and training for the team.

  2. Preventive maintenance

    Visits during the cycle to replace wear parts, review consumption, parameters and leaks, and avoid unplanned stoppages.

  3. Technical visits

    Inspections between maintenance visits, to check operation, answer questions and anticipate failures.

  4. End of cycle

    Cleaning, assessment of equipment condition and storage, so that it reaches the next cycle in good shape.

  5. Overhaul

    In-depth inspection at the shipyard or workshop when the equipment requires it, with service tests before returning to operation.

Always included

  • A written report after every visit.
  • Direct remote support with our engineers, at no additional cost.
  • Stock of critical spare parts in Chile.
  • Corrective assistance in the event of failure, with clear rates by area.

Request a proposal for your site

Contact

Tell us about
your project

Write to us with the type of site, the number of tanks or cages and the feed volume. We will reply with a technical proposal.

Sales

ventas@huber.cl · +56 00 000 0000

Technical support

soporte@huber.cl · +56 00 000 0000

Plant

Puerto Varas, Región de Los Lagos

Support on WhatsApp